12425 - Established June, 2013 - all GRiSO, all the time...
 
HomeFAQRegisterLog in

Share | 
 

 Wiring Diagram

View previous topic View next topic Go down 
AuthorMessage
Red Dog
Carlotto
Carlotto


Posts : 44
Join date : 2016-05-21
Age : 64

PostSubject: Wiring Diagram   Tue May 24, 2016 7:51 am

The GRiSO came with a license plate frame that had LED turn signals built in. I got stopped for: Failure to use Turn Signals.

The cops are real hard on sport bikes around here & I really don't blame them. We have a load of University students that are total idiots, nuff said.
I knew the cop & he said fix it because it really was not working at all. When I got home & pulled the seat the resistor was getting "burn yer hand" hot.

I pulled it off & trashed it. I thought I was going to be able to use a Digital volt meter to determine left side & right side flasher wires so I could put on a set of regular turn signals but I can't get any signals from any of the wires.

I have tried to find a wiring diagram for a 2013 SE but no luck.

Anybody have a diagram or a picture of the harness showing which wire does what so I can get it fixed?

Thanks.

PS: Gonna post this on Wild Guzzi also.
Back to top Go down
http://www.OtterTrout.com
wayne68
Carlotto
Carlotto


Posts : 33
Join date : 2014-08-28

PostSubject: Re: Wiring Diagram   Tue May 24, 2016 8:46 am

This any good? Might be hard to see but the earth wire is blue, right indicator is red, left is yellow

[You must be registered and logged in to see this image.]
Back to top Go down
Red Dog
Carlotto
Carlotto


Posts : 44
Join date : 2016-05-21
Age : 64

PostSubject: Re: Wiring Diagram   Tue May 24, 2016 9:23 am

@wayne68 Thank You! I did find that diagram but was not sure if any changes had been made after 2008.

I thought I had probed those wires and did not get a current change on the meter but I will do it again tonite. It may be that I need to have both lights wired and grounded before it will work.
Back to top Go down
http://www.OtterTrout.com
wayne68
Carlotto
Carlotto


Posts : 33
Join date : 2014-08-28

PostSubject: Re: Wiring Diagram   Tue May 24, 2016 10:54 am

No probs. You could just wait until you get the new ones and test before fitting.  Might just be a duff resistor though, ebay have them very cheap.
Back to top Go down
pauldaytona
Fra Cristoforo
Fra Cristoforo


Posts : 383
Join date : 2014-01-07

PostSubject: Re: Wiring Diagram   Tue May 24, 2016 12:15 pm

resistors are for turnautomats working with bimetal, what depends on the current draw to heat it. Yours has turn signals comming from the dash, get the resistor out. Or first try to get it running with a 21watt bulb, what is stock.

signals both have a blue, that is ground, and right has a black wire for +12v, left has yellow for +12v
Back to top Go down
http://www.fastguzzi.nl
beetle
GRiSO
GRiSO


Posts : 3968
Join date : 2013-09-30

PostSubject: Re: Wiring Diagram   Tue May 24, 2016 2:06 pm

Bloody hell. Your all wrong.

Loom wiring: Left +12V is Sky Blue
Right +12V is Red

Ground is Blue


Stock blinkies: +12V is Black, Ground is Blue.
Back to top Go down
pauldaytona
Fra Cristoforo
Fra Cristoforo


Posts : 383
Join date : 2014-01-07

PostSubject: Re: Wiring Diagram   Tue May 24, 2016 4:03 pm

beetle is right, I didn't see that it has colors from loom and blinkies both in the drawing
Back to top Go down
http://www.fastguzzi.nl
Sponsored content




PostSubject: Re: Wiring Diagram   Today at 12:45 am

Back to top Go down
 
Wiring Diagram
View previous topic View next topic Back to top 
Page 1 of 1

Permissions in this forum:You cannot reply to topics in this forum
GRiSO ghetto :: The Ghetto :: GRiSOLOGY-
Jump to: