Eire1400
GRiSO Capo
Posts : 74
Join date : 2018-07-20
Age : 45
 |  Subject: new title.  Sat Oct 20, 2018 7:38 am | |
| 2010 v8 rollerised GRiSO with 17k miles,
Last edited by Eire1400 on Mon Aug 10, 2020 10:01 pm; edited 2 times in total (Reason for editing : lost utube link. no longer valid.) | |
|
motor-timothy
GRiSO Capo
Posts : 520
Join date : 2016-12-21
| | Subject: Re: new title. Sat Oct 20, 2018 8:35 am | |
| I've heard that rattle (or very similar) in several video's of modern guzzi's. For example: [You must be registered and logged in to see this link.] (GRiSO) & [You must be registered and logged in to see this link.] (breva) Can't really help you identifying the cause, as my bike doesn't have it and never has. Just to state the obvious, did you check the valve clearances? | |
|
Pete Roper
GRiSO Capo
Posts : 9646
Join date : 2013-05-30
Age : 66
| | Subject: Re: new title. Sat Oct 20, 2018 8:39 am | |
| I'll have to try and listen to it on something better than my pad of eyes, the sound quality is shit.
Is it a sort of 'Dack-Dack-Dack' or 'Bonk-Bonk-Bonk' noise? If so I'd be pulling therod caps for a looksee. There again it could just be rattly chains.
Pete | |
|
Pete Roper
GRiSO Capo
Posts : 9646
Join date : 2013-05-30
Age : 66
| | Subject: Re: new title. Sat Oct 20, 2018 8:41 am | |
| The GRiSO one in Timothy's post definitely has a fucked bottom end. | |
|
Brent S
Biondino
Posts : 265
Join date : 2015-10-20
Age : 50
| | Subject: Re: new title. Sat Oct 20, 2018 3:01 pm | |
| Sounds like valvetrain noise, but hard to say with all the other noises going on. Perhaps try pulling the clutch lever in for a bit which eliminates the dry clutch rattle noises. Usually makes it much easier to identify noisy tappets etc when the clutch noise is removed from the equation. | |
|
Guest
Guest
| | Subject: Re: new title. Sat Oct 20, 2018 4:04 pm | |
| Screw driver in the ear can sometimes help locate area of noise creation. |
|
waterbottle
GRiSO Capo
Posts : 1785
Join date : 2015-02-03
Age : 61
| | Subject: Re: new title. Sat Oct 20, 2018 4:45 pm | |
| - Pete Roper wrote:
- The GRiSO one in Timothy's post definitely has a fucked bottom end.
That ones not good  If it's had jap bike oil put in it , too thin , change it to the correct 10w60 full synthetic spec, it will quiet it a little | |
|
Eire1400
GRiSO Capo
Posts : 74
Join date : 2018-07-20
Age : 45
| | Subject: Re: new title. Sun Oct 21, 2018 4:39 am | |
| Thanks for replies lads. Out today for a spin and that rattle was no where to be heard. Got well warmed too. Will check valves and do a service with correct oil (got a service kit minus oil from previous owner) now. .. to start reading oil threads!! | |
|
