Assumed bike forward of gearbox to be heavier, WRONG
Have seen others with tie downs at the front, assumed was overkill WRONG
Don't have anywhere can affix front tie downs, so chanced me arm.
Majority of weight is rearward but there is a fine line, yep think I crossed that
Total bitch to try and lift the back end and refit the Becker stand.
It's bad enough just trying to fit the becker stand on its own and have it not slip off the bolt head and gouge into your side plate
On a side note who the f*ck designed the rear wheel fittment, anybody have his email address so I can verbally abuse them.
Found a bolt that fits other than a wheel bolt, just getting a mate to grind the head off to use the bolt as a guide.
As is use a block of wood to assist which is almost the right height.
Can see why people pay to have others remove the wheel for a tyre change, so they can chuckle as the f*cker curses and swears at that stupid design
Here have a laugh at my expense [You must be registered and logged in to see this image.]