Replacing stock headlamp w LED. Stuck (for the moment) to

Replacing headlamp with LED Sktyants 7.7 black (like one already mentioned on this thread)
I see that the wire connection on the bike from the stock light is a 4 prong small box connector. The new LED is a plug and go. The stock cable/wires lead behind the instrument panel.
Not sure what next move is.
Any help would be appreciated!
Mike

Is the new one an H4 configuration plug with 3 prongs?  One is high, one is low, one is ground. If you also have a wire it's usually the park lite.

OK, just looked at wire diag, 4 prongs are high, low, ground, running light(park)

I thought there was a thread on this?

Yes it is: 2 parallel, and one horizontal below

I think you have to unpin the plug of stock and wire a H4 connector on wires.
I use the heavy duty ones made with ceramic, not plastic.


[You must be registered and logged in to see this link.]



Wiring diag==============

[You must be registered and logged in to see this link.]

Hey Steve! Got the ceramic H4 plug. Regarding the stock pin, it has 4 wires. Any experience with the correct routing to the H4’s 3 connecting wires?
Pretty sure one is hi beam, another is low beam, and then a ground wire.
This new headlamp has a Halo ring as well. Might be a trial and error situation, but I thought I’d circle back on it.
Thanks man.

Coloring is on the wiring schematic I posted. There is one for ring if you use that as park.


Stock on bike is


Just looked   Black & white is high & low beams---------Don't know which is which. Might have to swap back & forth.

Blue is ground wire

Yellow / gray is the park wire

Your plug (Male plug)
Looking at your pins----------Top is horizontal= Low beam
Right side vertical= High beam
Left side vertical= Ground




There you have it, Good Luck