GRiSO ghetto
Would you like to react to this message? Create an account in a few clicks or log in to continue.


12425 - Established June, 2013 - all GRiSO, all the time...
 
HomeRegisterLog in

GRiSO ghetto :: The Ghetto :: GRiSO Inspiration
 

 Tire clearance from these angle I want to Install ?

Go down 
AuthorMessage
Pisano
GRiSO Capo
GRiSO Capo
Pisano


Posts : 156
Join date : 2016-07-07
Age : 51

Tire clearance from these angle I want to Install ? Empty
PostSubject: Tire clearance from these angle I want to Install ?   Tire clearance from these angle I want to Install ? Icon_minitime1Fri Jun 15, 2018 9:33 am
Hello,
Looking at installing 3/4" ( 1/8" thick ) steel angle like below.  Issues with tire clearance?



[You must be registered and logged in to see this image.]

Thanks!
Back to top Go down
Guest
Guest
avatar



Tire clearance from these angle I want to Install ? Empty
PostSubject: Re: Tire clearance from these angle I want to Install ?   Tire clearance from these angle I want to Install ? Icon_minitime1Fri Jun 15, 2018 2:56 pm
1. Jack bike up so wheel is off the ground.
2. Measure vertically from tyre to angle.
3. compare with factory suspension travel spec.
Back to top Go down
 
Tire clearance from these angle I want to Install ?
Back to top 
Page 1 of 1
 Similar topics
-
» Right Angle valve stem adapter.
» Tip over switch/bank angle sensor
» New CRG Lever install
» Anyone install these items?
» Pazzo lever install question: Pivot Bolt

Permissions in this forum:You cannot reply to topics in this forum
GRiSO ghetto :: The Ghetto :: GRiSO Inspiration-
Jump to: